Page 1 of 1
Installing new campy wheelset questions
Posted: Mon Sep 23, 2013 8:41 pm
by andione1983
Do I need to install a spoke protector is it necessary?
Sent from my Galaxy far far away....
Re: Installing new campy wheelset questions
Posted: Mon Sep 23, 2013 8:59 pm
by macca33
No you don't have to, just be sure the rear derailleur inner limit screw is properly set - if it was right for your other wheelset, it'll be very close for this one.
cheers
Re: Installing new campy wheelset questions
Posted: Mon Sep 23, 2013 9:36 pm
by andione1983
Yeah just took it for a ride.. She's pretty good... All gears select ok these wheels roll brilliantly. Do i need to grease the skewers? Any particular grease? I have grease here which in use on model helicopter main shafts... Any good? Lol
Sent from my Galaxy far far away....
Re: Installing new campy wheelset questions
Posted: Mon Sep 23, 2013 9:43 pm
by Dan
You don't need to grease the skewers.
Re: Installing new campy wheelset questions
Posted: Mon Sep 23, 2013 9:47 pm
by andione1983
Dan wrote:You don't need to grease the skewers.
Ok thanks... Just noticed the old skewers from old wheelset had grease on them after removing...
Another noobie question.
Is it normal for these campy Zondas to make a ticking noise when spun backwards? Not loud just a small rapid ticking coming from the hub
Sent from my Galaxy far far away....