2 inches too short

Low Racer
Posts: 386
Joined: Wed May 21, 2008 7:04 pm
Location: Coffs Harbour

2 inches too short

Postby Low Racer » Sun Sep 07, 2008 7:41 pm

Hi guys,
Just re-read the M5 spec again and I am unfortunately 2 inches shorter than the recommended minimum of 33 inches Inseam with a 650c front wheel. I thought the measurement was similar to x-seam which I am approx 40 inches.

I am worry now that I might not be able to reach the pedals. Might have to saw off 2 inches of the boom to accomodate my short legs.

Chong

User avatar
Kalgrm
Super Mod
Super Mod
Posts: 9615
Joined: Fri May 25, 2007 5:21 pm
Location: Success, WA
Contact:

Postby Kalgrm » Sun Sep 07, 2008 8:12 pm

Don't give up hope Chong. If it turns out you have trouble, your first step should be to find short cranks (~150mm). That will immediately give you 1", combined with better spinning and power output. (Flame suit on for the uninitiated in these discussions re 'bents and crank lengths ... ;))

The next step I'd try would be extra padding under the cushion to effectively push you forward. You could get another inch that way.

Cheers,
Graeme
Think outside the double triangle.
---------------------
Music was better when ugly people were allowed to make it ....

Low Racer
Posts: 386
Joined: Wed May 21, 2008 7:04 pm
Location: Coffs Harbour

Postby Low Racer » Sun Sep 07, 2008 8:57 pm

Hi Graeme,
The shorter cranks was my first thought. Didn't think of the padding. I will know when it is here by end of this week (hopefully).

Thanks

Chong

User avatar
bradwoodbr
Posts: 411
Joined: Mon Jun 16, 2008 1:12 pm
Location: Perth Western Australia
Contact:

Postby bradwoodbr » Mon Sep 08, 2008 1:19 am

I use 150mm cranks and they do give better power output but at a higher cadence. They will certainly reduce front wheel and foot overlap. Check handlebar and stem length adjustments as well. I am sure Ian Humphries will have pretty good advice for you. Cheers

Who is online

Users browsing this forum: No registered users