Page 1 of 1

Belt Drive

Posted: Fri May 24, 2013 9:03 am
by Sparx
I have an Avanti Inc 3 with Gates carbon belt drive. I am struggling to figure out how to re-fit the belt after taking the wheel off. According to Gates you are not supposed to 'walk' the belt back on. By this I take it to mean putting the belt partially on the chain wheel and turning the cranks. This is what I have been doing however I did notice a bit of fraying on the belts teeth.

Any ideas?

Re: Belt Drive

Posted: Fri May 24, 2013 11:01 am
by Crawf
Could also ask in here - viewtopic.php?f=41&t=43485

Re: Belt Drive

Posted: Mon Jun 10, 2013 1:32 am
by CrashBoomBang
Here is Gates' instructional video on installing the belt: http://www.youtube.com/watch?v=0khWNhxhG5s
Hope that helps.