Di2 MTB connectors...

User avatar
RonK
Posts: 10265
Joined: Mon Aug 24, 2009 2:08 pm
Location: Brisbane, Queensland
Contact:

Di2 MTB connectors...

Postby RonK » Thu Jul 26, 2018 10:17 am

Does anybody know where I can find information about the Di2 connectors used with Shimano Steps E8000 drives?

I'm planning to change the flat bars on my new e-mtb for riser bars. The assist mode controller is wired to the display through the handlebar and stem, so I just need to know how the disconnect/reconnect the wiring.

Image
Image
Cycle touring blog and tour journals: whispering wheels...

User avatar
RonK
Posts: 10265
Joined: Mon Aug 24, 2009 2:08 pm
Location: Brisbane, Queensland
Contact:

Re: Di2 MTB connectors...

Postby RonK » Thu Jul 26, 2018 10:28 am

Ah - I see. That is what the Shimano TL-EW02 Di2 Plug Tool is for.
Cycle touring blog and tour journals: whispering wheels...

User avatar
Duck!
Expert
Posts: 6975
Joined: Tue May 21, 2013 8:21 pm
Location: On The Tools

Re: Di2 MTB connectors...

Postby Duck! » Thu Jul 26, 2018 10:44 am

Use the TL-EW02 plug tool which should have been supplied with the bike.
I had a thought, but it got run over as it crossed my mind.

User avatar
RonK
Posts: 10265
Joined: Mon Aug 24, 2009 2:08 pm
Location: Brisbane, Queensland
Contact:

Re: Di2 MTB connectors...

Postby RonK » Thu Jul 26, 2018 10:53 am

Duck! wrote:Use the TL-EW02 plug tool which should have been supplied with the bike.

Yes, just worked that out. I did get one and wondered what it was for. Thanks Duck.

Image
Cycle touring blog and tour journals: whispering wheels...

User avatar
Duck!
Expert
Posts: 6975
Joined: Tue May 21, 2013 8:21 pm
Location: On The Tools

Re: Di2 MTB connectors...

Postby Duck! » Thu Jul 26, 2018 11:04 am

Use the forked end to pull the plug out - there's a groove around the plug for it to fit into - and use the other end to push it back in.
I had a thought, but it got run over as it crossed my mind.

Who is online

Users browsing this forum: No registered users