Bont Heat Molding

Posts: 29
Joined: Thu May 23, 2013 1:17 pm

Bont Heat Molding

Postby Mr.W » Fri Nov 08, 2013 3:14 pm

Few questions for all Bont shoe users:

I just purchased a pair of Bont Riots from a fellow member and will be receiving them in the mail early next week.

My questions:

- Are there any tips/tricks that you found assisted in getting the best possible fit?
- Did you find going through the process just once was sufficient or should I do it a couple times?
- once I have the heated shoes on my feet should I stand up to let it mould or just stay seated? Can standing while the shoe is soft deform it in a negative way?
- Is there a risk of deforming the shoe too much if I do something wrong?

I know I might be asking many questions about a process that seems fairly simple, I just want to make sure I don't wreck the shoes.

Any help is appreciated.

User avatar
biker jk
Posts: 6018
Joined: Tue Nov 17, 2009 6:18 pm
Location: Sydney

Re: Bont Heat Molding

Postby biker jk » Fri Nov 08, 2013 3:33 pm

See instruction video below. I used an oven thermometer to get the temperature correct since the minimum temperature on my oven was 100 degrees celsius. You need to stand in the shoes but not walk in them as this can crack the carbon. I only needed to mold mine once but a friend has done it 4-5 times.

Posts: 8699
Joined: Thu Sep 18, 2008 12:10 pm
Location: Sydney

Re: Bont Heat Molding

Postby Nobody » Fri Nov 08, 2013 3:57 pm

Posts: 442
Joined: Tue Feb 07, 2012 3:48 pm

Re: Bont Heat Molding

Postby Jesmol » Fri Nov 08, 2013 7:41 pm

I did mine about 3 times, using a oven thermometer, fairly easy. Don't walk /stand in them until they are cool though.

I did wear two pairs of thin cycling socks

Sent from my GT-N8010 using Tapatalk 4

Posts: 29
Joined: Thu May 23, 2013 1:17 pm

Re: Bont Heat Molding

Postby Mr.W » Thu Nov 14, 2013 12:33 pm

Thanks for the tips guys.

Took the shoes for their first ride yesterday... love them!

Who is online

Users browsing this forum: No registered users