Maybe you can offer some advice...
My current gearing is 48-15 and I am finding it a little high for races over 6 laps.
Today I purchased two new rear sprockets...a 16T and a 17T. I fitted the 17T but the reduced chain length meant that the rear tyre was hard against the seat tube. So no good, and same with the 16T.
How do you recommend I lower the gearing...
1) Get a longer chain and use the 16 or 17T sprockets.
2) Get a smaller front chain ring.
I have calculated the ratios as follows...
48-15 = 3.20 (current)
46-15 = 3.07
48-16 = 3.00 (need longer chain)
46-16 = 2.88
48-17 = 2.82 (need longer chain)
46-17 = 2.71
So maybe the 46-16 would be a good choice hopefully without needing to change the chain, and enable the rear wheel to have enough clearance to clear the seat tube.
Any suggestions?
Emma
Advice on gearing options requested...
- CoffsGal
- Posts: 1000
- Joined: Mon Sep 22, 2008 8:35 pm
- Location: Mid North Coast NSW
- jacks1071
- Posts: 3068
- Joined: Thu Aug 20, 2009 9:47 pm
- Location: Mackay, QLD
- Contact:
Re: Advice on gearing options requested...
Postby jacks1071 » Thu Nov 26, 2009 10:16 pm
Em - you'll need another chain if you get serious about playing with gearing so just buy one and run two chains. Obviously make sure you don't cut them the same length!CoffsGal wrote:Maybe you can offer some advice...
My current gearing is 48-15 and I am finding it a little high for races over 6 laps.
Today I purchased two new rear sprockets...a 16T and a 17T. I fitted the 17T but the reduced chain length meant that the rear tyre was hard against the seat tube. So no good, and same with the 16T.
How do you recommend I lower the gearing...
1) Get a longer chain and use the 16 or 17T sprockets.
2) Get a smaller front chain ring.
I have calculated the ratios as follows...
48-15 = 3.20 (current)
46-15 = 3.07
48-16 = 3.00 (need longer chain)
46-16 = 2.88
48-17 = 2.82 (need longer chain)
46-17 = 2.71
So maybe the 46-16 would be a good choice hopefully without needing to change the chain, and enable the rear wheel to have enough clearance to clear the seat tube.
Any suggestions?
Emma
Personally I push a 15/50. I find 14/50 is good for longer races especially when the pace gets up as long as there isn't much surging. If you're doing a points race you want something a bit higher maybe 16/50 so you can kick a bit without cooking yourself otherwise get on the front and drive it with a bigger gear hoping everyone else has gone high. You've just gotta play with the gears to work it out - no-one can really advise you too much as everyone is different. Most good female riders I know can spin quicker than a guy of similar abilities so you might be able to spin a gear that would have me bouncing like a 2 dollar hooker - you just gotta expriment. I'd probably add a front 50 and a 46 to your tool box. You can't fine tune the gears with the rear sprocket as the steps are just too big.
Our Website is: http://www.kotavelo.com.au" onclick="window.open(this.href);return false; Find us on Facebook by searching for "Kotavelo"
- CoffsGal
- Posts: 1000
- Joined: Mon Sep 22, 2008 8:35 pm
- Location: Mid North Coast NSW
Re: Advice on gearing options requested...
Postby CoffsGal » Thu Nov 26, 2009 10:55 pm
Thanks Jack,jacks1071 wrote: Em - you'll need another chain if you get serious about playing with gearing so just buy one and run two chains. Obviously make sure you don't cut them the same length!
Personally I push a 15/50. I find 14/50 is good for longer races especially when the pace gets up as long as there isn't much surging. If you're doing a points race you want something a bit higher maybe 16/50 so you can kick a bit without cooking yourself otherwise get on the front and drive it with a bigger gear hoping everyone else has gone high. You've just gotta play with the gears to work it out - no-one can really advise you too much as everyone is different. Most good female riders I know can spin quicker than a guy of similar abilities so you might be able to spin a gear that would have me bouncing like a 2 dollar hooker - you just gotta expriment. I'd probably add a front 50 and a 46 to your tool box. You can't fine tune the gears with the rear sprocket as the steps are just too big.
I will get the second chain I think, and try the 48-16 and 48-17 combinations at this weekend's meet. if I need something in between I will try a 46T chain ring.
Cheers.
Em
- CoffsGal
- Posts: 1000
- Joined: Mon Sep 22, 2008 8:35 pm
- Location: Mid North Coast NSW
Re: Advice on gearing options requested...
Postby CoffsGal » Sat Nov 28, 2009 9:56 pm
Purchased a new chain and replaced the 15T with the 17T sprocket...went to the track comp this arvo and found the 17T made me spin too fast...fitted the 16T and it was much better...
ratios...
48-15 = 3.20 (too hard)
48-16 = 3.00 (just right)
48-17 = 2.82 (too easy)
ratios...
48-15 = 3.20 (too hard)
48-16 = 3.00 (just right)
48-17 = 2.82 (too easy)
-
- Posts: 1000
- Joined: Fri Nov 28, 2008 10:12 am
Re: Advice on gearing options requested...
Postby alex » Thu Dec 03, 2009 11:15 am
what grade are you in and how old are you?
48/16 is 81 inches which is a tiny gear but i am not really familiar with how the fairer sex set up their track bikes
48/16 is 81 inches which is a tiny gear but i am not really familiar with how the fairer sex set up their track bikes
if i get killed while out on my bike i dont want a 'memorial ride' by random punters i have never met.
- Verbs & Nouns
- Posts: 778
- Joined: Wed Jul 23, 2008 9:13 am
- Location: Australia, South
Re: Advice on gearing options requested...
Postby Verbs & Nouns » Thu Dec 03, 2009 3:00 pm
77.8" is a fun street gear.
Ten Grand wrote:Goddamnit baby, this is soul... What's wrong with you?
- CoffsGal
- Posts: 1000
- Joined: Mon Sep 22, 2008 8:35 pm
- Location: Mid North Coast NSW
Re: Advice on gearing options requested...
Postby CoffsGal » Thu Dec 03, 2009 7:06 pm
Have been competing in road and crits (C grade) for 11 months...best crit average 35.9kph...racing track for 3 weeks...I am 56yo...alex wrote:what grade are you in and how old are you?
48/16 is 81 inches which is a tiny gear but i am not really familiar with how the fairer sex set up their track bikes
The 48/16 does have me spinning quite a bit but seems appropriate for the moment...maybe when I grow up I will try a higher gear...
-
- Posts: 1000
- Joined: Fri Nov 28, 2008 10:12 am
Re: Advice on gearing options requested...
Postby alex » Fri Dec 04, 2009 2:23 pm
sounds like it works for you which is all that matters
was just curious re your age etc !
was just curious re your age etc !
if i get killed while out on my bike i dont want a 'memorial ride' by random punters i have never met.
Jump to
- General Australian Cycling Topics
- Info / announcements
- Buying a bike / parts
- General Cycling Discussion
- The Bike Shed
- Cycling Health
- Cycling Safety and Advocacy
- Women's Cycling
- Bike & Gear Reviews
- Cycling Trade
- Stolen Bikes
- Bicycle FAQs
- Serious Biking
- Audax / Randonneuring
- Retro biking
- Commuting
- MTB
- Recumbents
- Fixed Gear/ Single Speed
- Track
- Electric Bicycles
- Cyclocross and Gravel Grinding
- Dragsters / Lowriders / Cruisers
- Children's Bikes
- Cargo Bikes and Utility Cycling
- Road Racing
- Road Biking
- Training
- Time Trial
- Triathlon
- International and National Tours and Events
- Cycle Touring
- Touring Australia
- Touring Overseas
- Touring Bikes and Equipment
- Australia
- Western Australia
- New South Wales
- Queensland
- South Australia
- Victoria
- ACT
- Tasmania
- Northern Territory
- Country & Regional
- The Market Place
- Member to Member Bike and Gear Sales
- Want to Buy, Group Buy, Swap
- My Bikes or Gear Elsewhere
- Cycling Brands
- Cannondale
- Garmin
- Giant
- Shimano
- Trek
Who is online
Users browsing this forum: No registered users
- All times are UTC+11:00
- Top
- Delete cookies
About the Australian Cycling Forums
The Australian Cycling Forums is a welcoming community where you can ask questions and talk about the type of bikes and cycling topics you like.
Bicycles Network Australia
Forum Information
Connect with BNA
Brought to you by Bicycles Network Australia | © 1999 - 2024 | Powered by phpBB ®
This website uses affiliate links to retail platforms including ebay, amazon, proviz and ribble.
This website uses affiliate links to retail platforms including ebay, amazon, proviz and ribble.