Stripping down Weinmann 500 calipers

Seele
Posts: 44
Joined: Fri May 11, 2007 12:54 pm
Location: Sydney
Contact:

Stripping down Weinmann 500 calipers

Postby Seele » Tue Sep 11, 2007 2:46 am

I think I can say that I have worked on a fair few Weinmann side-pulls, stripping and rebuilding them, but they're all earlier ones with a nut at the front and a "Weinmann" marked washer underneath.

What I am trying to work on now is another pair of black 500s, with quick-release lever at the housing side. Instead of a nut it has the black plastic knurled cylinder instead with a thin hexagonal pin in the middle. I cannnot figure out how to strip it down. Any advice?

User avatar
LuckyPierre
Posts: 1432
Joined: Fri Jul 14, 2006 4:37 pm
Location: Canberra, ACT

Postby LuckyPierre » Tue Sep 11, 2007 9:26 am

Photo's please!
Litespeed Classic - 3Al/2.5V titanium tube set, Record 9-speed groupset, Open Corsa Evo CX
Alchemy Diablo - Columbus Zonal tubing, Ultegra 9-speed groupset, UltraGatorskins
Gitane Rocks T1 - U6 tubing, Deore/XT groupset, CrossMarks

Seele
Posts: 44
Joined: Fri May 11, 2007 12:54 pm
Location: Sydney
Contact:

Postby Seele » Tue Sep 11, 2007 11:59 pm

The nut type Weinmann is this...

http://i185.photobucket.com/albums/x101 ... nmann1.jpg

The type with plastic cylinder at the front is this...

http://i185.photobucket.com/albums/x101 ... nmann2.jpg

User avatar
europa
Posts: 7333
Joined: Sun Jul 16, 2006 10:51 am
Location: southern end of Adelaide - home of hills, fixies and drop bears

Postby europa » Wed Sep 12, 2007 10:20 am

Hmm, I've seen them, though never played with them. I just assumed the plastic cylinder turned off like a nut. It doesn't lever off to expose a nut does it?

Richard
I had a good bike ... so I fixed it

Seele
Posts: 44
Joined: Fri May 11, 2007 12:54 pm
Location: Sydney
Contact:

Postby Seele » Wed Sep 12, 2007 6:57 pm

Richard,

The knurled plastics cylinder at the front just turns around, held down by the fastener which holds the whole thing together; I think it is some sort of a nut turned by the thin hexagonal shaft in the middle. A design which prevents them being messed with by those who do not know what they are doing, but also prevents those who know what they are doing to service them.

Who is online

Users browsing this forum: davehirst, WyvernRH