I am a total newbie to MTB and whilst i haven't had a flat yet, I would like to get some tips on recommended tyre pressure for trails / rocks.
Are there any recommended pressures at all ? My tyres have a 40-65 psi (2.8 - 4.5 bar) rating.
Any help would be appreciated !
MTB tyre pressure
-
- Posts: 7
- Joined: Thu Nov 23, 2006 2:45 pm
- toolonglegs
- Posts: 15463
- Joined: Fri Jun 29, 2007 7:49 pm
- Location: Somewhere with padded walls and really big hills!
Postby toolonglegs » Sun Jan 13, 2008 5:52 pm
35 -40 psi...You will get flats more from not being smooth over the rough stuff than tyre pressures as a newbie.
Postby Hawkeye » Sun Jan 13, 2008 6:31 pm
Depends on your combined bike+rider weight, plus the terrain, plus the bike. I'm about 85-87kg fully laden and the dual-suspended bike another 13kg. I run my WTB Velociraptors around Manly Dam at about 40psi. Traction is good enough and I've yet to pinch flat. I could go lower to about 35psi but wouldn't like to be too much less around the dam,
<image snipped>
<image snipped>
Last edited by Hawkeye on Sat Feb 09, 2008 8:39 pm, edited 1 time in total.
- Kalgrm
- Super Mod
- Posts: 9653
- Joined: Fri May 25, 2007 5:21 pm
- Location: Success, WA
- Contact:
Postby Kalgrm » Sun Jan 13, 2008 9:08 pm
As others have said, it depends on the way you ride, your weight, the track conditions and your tyre widths. Most beginners put too much pressure in their tyres: an error aided by tyre makers who are scared of having their pants sued off them (45psi is too high for nearly everybody under nearly all off-road conditions).
Since I can't advise you precisely, I'll give you my details and you can extrapolate:
My bike and I weigh in at around 95kg with water, tools and clothes. I'm riding a FS bike (Specialized Epic) for cross country riding. My tyres are 2.1" wide. The tracks I ride vary from very rocky to pea gravel to hard-packed dirt. I use tubes.
At Lysterfield (smooth groomed hard-pack with a few rocks and some tame log-overs) I was running 30psi in the rear and 28 in the front. At home in the west, it's pea gravel and sharpish rocks, so I run 32psi on the rear and 30psi on the front. One particular track has some DH stuff (sharp rocks, terrible lines) on it, so I need to run 36psi R and 34psi F.
Tubeless tyres obviously can't pinch flat, so you can run lower pressure with them.
The principle is to use the lowest pressure you can without pinch flatting. Start with your tyres at say 35psi and lower them a little bit at a time on a ride until you think you will pinch flat (or actually do such), then put 3 to 5 psi back in. From there, you can work your pressures to suit your track conditions.
Cheers,
Graeme
Since I can't advise you precisely, I'll give you my details and you can extrapolate:
My bike and I weigh in at around 95kg with water, tools and clothes. I'm riding a FS bike (Specialized Epic) for cross country riding. My tyres are 2.1" wide. The tracks I ride vary from very rocky to pea gravel to hard-packed dirt. I use tubes.
At Lysterfield (smooth groomed hard-pack with a few rocks and some tame log-overs) I was running 30psi in the rear and 28 in the front. At home in the west, it's pea gravel and sharpish rocks, so I run 32psi on the rear and 30psi on the front. One particular track has some DH stuff (sharp rocks, terrible lines) on it, so I need to run 36psi R and 34psi F.
Tubeless tyres obviously can't pinch flat, so you can run lower pressure with them.
The principle is to use the lowest pressure you can without pinch flatting. Start with your tyres at say 35psi and lower them a little bit at a time on a ride until you think you will pinch flat (or actually do such), then put 3 to 5 psi back in. From there, you can work your pressures to suit your track conditions.
Cheers,
Graeme
Think outside the double triangle.
---------------------
Music was better when ugly people were allowed to make it ....
---------------------
Music was better when ugly people were allowed to make it ....
Postby Hawkeye » Sun Jan 13, 2008 11:14 pm
Thanks for sharing your experience. I might run mine a little lower, then, if you seem to be getting away with pressures like that.
A thought, though: do you reckon a hardtail would be a little more likely to pinchflat on the rear, without the rear suspension to cushion the jolt at the upper limit of drops you'd take on such a bike - especially with a less experienced rider on board (and I'd include myself there)?
A thought, though: do you reckon a hardtail would be a little more likely to pinchflat on the rear, without the rear suspension to cushion the jolt at the upper limit of drops you'd take on such a bike - especially with a less experienced rider on board (and I'd include myself there)?
- Kalgrm
- Super Mod
- Posts: 9653
- Joined: Fri May 25, 2007 5:21 pm
- Location: Success, WA
- Contact:
Postby Kalgrm » Mon Jan 14, 2008 7:49 am
J.R.,
I was running about 2 psi more on my HT, but I never really tried to go much lower than that. I'd say 2 - 5 psi more in tyres on a HT (esp. the rear) might be a wise thing, but if you use the "5 psi over pinch flat pressure" technique, you'll be able to set it for your own style of riding (including the HT consideration).
Cheers,
Graeme
I was running about 2 psi more on my HT, but I never really tried to go much lower than that. I'd say 2 - 5 psi more in tyres on a HT (esp. the rear) might be a wise thing, but if you use the "5 psi over pinch flat pressure" technique, you'll be able to set it for your own style of riding (including the HT consideration).
Cheers,
Graeme
Think outside the double triangle.
---------------------
Music was better when ugly people were allowed to make it ....
---------------------
Music was better when ugly people were allowed to make it ....
Jump to
- General Australian Cycling Topics
- Info / announcements
- Buying a bike / parts
- General Cycling Discussion
- The Bike Shed
- Cycling Health
- Cycling Safety and Advocacy
- Women's Cycling
- Bike & Gear Reviews
- Cycling Trade
- Stolen Bikes
- Bicycle FAQs
- Serious Biking
- Audax / Randonneuring
- Retro biking
- Commuting
- MTB
- Recumbents
- Fixed Gear/ Single Speed
- Track
- Electric Bicycles
- Cyclocross and Gravel Grinding
- Dragsters / Lowriders / Cruisers
- Children's Bikes
- Cargo Bikes and Utility Cycling
- Road Racing
- Road Biking
- Training
- Time Trial
- Triathlon
- International and National Tours and Events
- Cycle Touring
- Touring Australia
- Touring Overseas
- Touring Bikes and Equipment
- Australia
- Western Australia
- New South Wales
- Queensland
- South Australia
- Victoria
- ACT
- Tasmania
- Northern Territory
- Country & Regional
- The Market Place
- Member to Member Bike and Gear Sales
- Want to Buy, Group Buy, Swap
- My Bikes or Gear Elsewhere
- Cycling Brands
- Cannondale
- Garmin
- Giant
- Shimano
- Trek
Who is online
Users browsing this forum: No registered users
- All times are UTC+11:00
- Top
- Delete cookies
About the Australian Cycling Forums
The Australian Cycling Forums is a welcoming community where you can ask questions and talk about the type of bikes and cycling topics you like.
Bicycles Network Australia
Forum Information
Connect with BNA
Brought to you by Bicycles Network Australia | © 1999 - 2024 | Powered by phpBB ®
This website uses affiliate links to retail platforms including ebay, amazon, proviz and ribble.
This website uses affiliate links to retail platforms including ebay, amazon, proviz and ribble.