Workshop tales, trials and disasters.
Maintenance tips, techniques and myths.
Technical discussion, description and outright lies
13 posts • Page 1 of 1
I have zipp 101 wheels with ultegra group set. Noise was coming from the rear cassette, on inspection i notice the rear cassette was loose. I took the cogs off and notice the aluminum hub cassette spline was notched badly creating movement with the cogs.
I sent an email to Zipp whom say that there is no solution except going to sram, that it was okay. Problem is too much noise
Anyone got a solution
Post a picture. Unless its chewed all the way through do the lockring up to 40Nm and it should be fine. If it is all the way through, just order a new freehub from your LBS.
This is exactly why you should use a torque wrench when doing up cassette lockrings.
Our Website is: http://www.pro-liteoz.com Find us on Facebook by searching for "Pro-Lite Australia"
I've destroyed two 188 hubs by ripping the spokes away from the flange on the drive side. Both times this resulted in the rim taking big gouges out of the chain stay. Even when 188 hubs are adjusted up well (bearing preload) the lateral deflection from the hubs are nothing short of terrible as well... Just my opinion however...
Damn, well I can only hope I don't have that problem I guess. Are you a big guy? Being light-ish might help me. There is not much room between the fat chainstays on my Tarmac so it would not take much. I run the pads real close and have no rubbing. Or are you talking about some other kind of flex? I have no idea what lateral deflection from the hub means!
The Zipp 188 hub flanges were too thin. I believe the newer models have thicker flanges.
Yeah correct... Version 2 of the 188 hubs have meatier flanges, due to the failure rate of the V1 188s. Both my replacement wheelsets look thicker in the flange, but I'm done with zipp. I'm not taking any chances with damaging my new frame by using their hubs.
I'm not sure if mine are V2. They are 2012FC 404 clinchers. Just had a look at the website and it doesn't seem to say. I'm 67kg heading towards 70 so that should help. I changed the cassette recently and had no spline damage. This leads me to theory that I am just pissweak
Or your lockring isn't loose...
...whatever the road rules, self-preservation is the absolute priority for a cyclist when mixing it with motorised traffic.
London Boy 29/12/2011
Its not chewed all the way through. I got the American classic parts from NRG Cycles: Cycles Brisbane
I can see how they help even the pressure accros the cassette hub. Work well
Welcome to NRG Cycles. NRG Cycles is all about family and friends. ... NRG Cycles store location: 30 Goggs Road, Homemaker Centre, Jindalee QLD.
13 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users