Workshop tales, trials and disasters.
Maintenance tips, techniques and myths.
Technical discussion, description and outright lies
8 posts • Page 1 of 1
Yesterday, I took my bike for first time on M7 cycleway and got a puncture...Really bad luck
I like to know if this puncture requires a change in tube and tyre both or only tube.
Tyres: Schwalbe Lugano 700x23c
Generally a typical puncher involving sharp items penetrate the tyre and tube would only require tube repair or replacement (depend on severity and preference). No need to replace the tyre.
Your photo from the link above appears to be a bit of cut on the tyre. If that area of tyre does not bulge or split exposing deeper layers of the tyre after inflation to working pressure, I will say it is safe to continue using it. Put a new tyre on if you don't feel safe. Tyres are relatively cheap when purchasing from major online retailers. I tend to change my tyres when puncher frequency picks up after 3-4000km.
I agree with this... I applied superglue to a bunch of cuts including sidewalls which later became quite brittle and started flaking. Just dont do it. If you must apply glue, dab some shoo goo onto it.
FOCUS Cayo Expert
Nah, not bad luck - it's just school holidays. Means bored little pre-driving teenage half-wits getting their
rocks off by smashing bottles on the cycleway.
Two riding buddies got flats on our regular weekly ride, last time anyone got a flat was previous
school holidays. Glass in both cases.
As for the cut mark, my vote is for the shoe-goo - smear some on the inside (well smoothed) as
well as filling it from the outside.
WombatK - Jerry Garcia, Grateful Dead
I've been testing shoo goo after a number of recomendations on here, it really does work brilliantly. I'm using a set of tyres that I was going to toss out due to cuts, I'll probably get another couple of thousand kms out of them.
Super glue is hopeless, gone in a short period of time and some users have reported that the hard glue actually punctured their tube - probably better off with nothing in that case.
Our Website is: http://www.pro-liteoz.com Find us on Facebook by searching for "Pro-Lite Australia"
8 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users