Weird CX brake lever problem

Workshop tales, trials and disasters.
Maintenance tips, techniques and myths.
Technical discussion, description and outright lies

Weird CX brake lever problem

Postby takai » Wed Mar 13, 2013 11:12 am

Ok, on my bitza commuter i have a pair of Kore CX levers in 31.8 i have had lying around for a fair while, and paired them with a cheap pair of Pro-Lite Vercelli 31.8 bars that i picked up from CRC ( http://www.chainreactioncycles.com/Mode ... elID=68379 ) when i was trying to figure out which style of bars i was after (and who can argue with $7 for bars)

Now my problem is that the ProLites are 31.8 through the clamp, but only have about 10mm either side of the clamp area which is 31.8, and after that they taper down to standard bar size (26mm?) Except that the taper is exceedingly long, and so mounting the brake lever at the 26mm point means that half of the lever sits outside of the bars.

Anyone know if there is a way of mounting the CX levers half way down the taper? I was thinking a tapered shim, but that would need to be relatively precise with the taper. Rubber is likely to slip i think as well after compression. Plus if i have the CX levers clamped on that ~10mm either side of the stem then the cables get tangled with each other and its a pain (plus not being symmetrical, one side needs to be higher).

I know new bars would fix this problem, but im trying to keep the bike cheap and cheerful :)

Thoughts? Suggestions? Should i just go find new bars?
takai
 
Posts: 159
Joined: Sun Sep 23, 2012 9:06 pm

by BNA » Wed Mar 13, 2013 1:12 pm

BNA
 

Re: Weird CX brake lever problem

Postby drubie » Wed Mar 13, 2013 1:12 pm

Just wind on some electrical tape - make it fatter where the taper is increased. The levers themselves don't need to be mounted super rigid, as long as they don't rotate too much you should be golden.
So we get the leaders we deserve and we elect, we get the companies and the products that we ask for, right? And we have to ask for different things. – Paul Gilding
but really, that's rubbish. We get none of it because the choices are illusory.
User avatar
drubie
 
Posts: 4617
Joined: Wed Oct 22, 2008 10:12 am
Location: New England

Re: Weird CX brake lever problem

Postby takai » Tue Mar 19, 2013 3:14 pm

Electrical tape is a no go. Its not the rotation but the leverage. The act of pulling on the lever slowly works them "down" the taper and so off the ET.
takai
 
Posts: 159
Joined: Sun Sep 23, 2012 9:06 pm


Return to The Shed

Who is online

Users browsing this forum: wqlava1



Popular Bike Shops
Torpedo 7 Torpedo7 AU
Ground Effect Ground Effect NZ
Chain Reaction Cycles CRC UK
Wiggle Wiggle UK
Ebay Ebay AU

“Bicycles BNA Twitter
“Bicycles BNA Facebook
“Google+ BNA Google+
“Bicycles BNA Newsletter

> FREE BNA Stickers
> BNA Cycling Kit
cron